The Common Fault of Cone Crusher

     When the oil quality is not good and insufficient;or if there is bearing damage and other problems, the problem of high oil temperature will occur.We just change the oil, or fuel, or replace the bearings to solve the above problem.When the oil temperature is low; the tubing will be clogged or the oil pump is not working properly. Which will cause low oil pressure or indicator without oil flow after the oil pump is started,heating should be used to increase the oil temperature and repair piping or pump. When hydraulic oil temperature rises,you should immediately stop cone crusher and make inspection repair, general because of tubing clogging or the oil groove, the safety valve will not work.When the oil contains large amounts of fine mud and impurities, generally because the sealed dust-proof device failured;          

     Plumbing blockage or leak is caused by shortage of water. You should stop reseal or cleaning overhaul, replace with new oil. Crushing or idling will produce an audible sound of splitting, it is also more common, because of the liner relaxation; movable cone or fixed cone lining will produce impact force. The solution is to down to check the fastening screws and zinc layer off. If the screws or earrings will be damaged, you need to remove the adjustment ring replacement screws and earrings; If the zinc layer is off, they need to re-cast zinc layer; Check the liner ovality, and make necessary machining. In addition, the increase in grain size of the row of ore is caused by severe liner wear, you should adjust the port of discharge, reduce the size of the port of discharge and replace liner.